Question
 | |  | | | 
Sep 17, 2003, 12:00 PM
| | New Member | | Join Date: Sep 2003 Location:
Posts: 2
| | | Truck Overheating I have a 96 Ford F 150 which is overheating. I had the radiator rebored about a year ago.
It overheated about a month ago and when I opened the cap it spewed for a short time. I added anti freeze and water. Then, it was ok for about a month.
It has started again. I checked the water levels and it is still full. I noticed steam inside my windshield (right hand passenger side) this morning and I am smelling anti freeze. I can't see any leaks at all.
Any advise will be appreciated.
Thanks!! | | | | | | |
Answers
 | |  | | |
Oct 26, 2003, 08:45 PM
|
#2
| | New Member
Join Date: Oct 2003 Location:
Posts: 1
| Re: Truck Overheating hello...
When you see steam inside you windshield and on the passenger side (accompanied by the smell of antifreeze) - your heater core is leaking...
The heater core is located behind the dashboard on the passenger side - The symptom of a bad heater core is leakage... this will cause your windshield to steam up on the passenger side and the smell of antifreeze in the cab... Also, in the advanced stages of heater core breakdown - you will actually get a puddle of antifreeze on the floorboards on the passenger side...
... |
| | | | | | |  | |  | | |
Oct 27, 2003, 06:49 AM
|
#3
| | New Member
Join Date: Sep 2003 Location:
Posts: 2
| Re: Truck Overheating Thanks for the info. Will that also cause it to get hot? Or are they two separate issues?
When going down the highway, it doesnt get hot, but when it's in traffic or idling, it does.
Thanks again! |
| | | | | | |  | |  | | |
Mar 21, 2004, 04:38 PM
|
#4
| | New Member
Join Date: Mar 2004 Location:
Posts: 2
| Re: Truck Overheating Try the thermostat also. Take it out and toss it in a pan of boiling water. If it opens it is good...If not, get a new one. Also, check your fans. I am not too familiar with your truck, but you may have an auxilary fan with a bad switch. Like the last guy said, your heater core needs to be replaced or you will end up with puddles in your front seat. Good luck.
-Josh |
| | | | | | |  | |  | | |
Mar 21, 2004, 06:36 PM
|
#5
| | Dogs Expert
Join Date: Feb 2003 Location: Northern US
Posts: 10,615
| Re: Truck Overheating Considering the price of thermostats and how tough getting some of them out is, I would tend to toss it in the trash and buy a new one. Maybe try boiling the new one before putting it in.
Check your belts and any fan clutch. How are your hoses? If they are soft and spongy, they can shut the flow of water off.
Let it set in the driveway and idle as it heats up. Feel the hoses and the radiator core and see if they are hot. You should not be able to squeeze the upper hose shut. Do not feel the fan or belts. Count on it at leash hurting if you get your hand in it.
Many heaters now have an outlet to make the puddles under the truck if they leak. Replace it anyways. It is more of a GM thing, but neglected minor coolant leaks can destroy an engine. |
| | | | | | |  | |  | | |
Jun 24, 2004, 11:19 AM
|
#6
| | New Member
Join Date: Jun 2004 Location:
Posts: 1
| Re: Truck Overheating Hello Dwood, I have a F150 4.2 L 6cil. and having the same problem...  I change the fan clutch one week ago because I was having a noise problem, and now my truck is getting hot, I put 50% Water and 50% AntiFreeze and I have the same situation, it is happening when the truck is not running, like in the stops, or traffic, not when the truck is running like the express way.
Did you found any solution?? It never happend to me before. |
| | | | | | |  | |  | | |
Jun 24, 2004, 12:55 PM
|
#7
| | Dogs Expert
Join Date: Feb 2003 Location: Northern US
Posts: 10,615
| Re: Truck Overheating f you weren't over heating before you changed the fan clutch, and are now, I would take a good look at the fan clutch, and also the belt. Make sure any shrouds you may have removed are correctly in place.
Have you opened the hood and looked to make sure the fan is turning rapidly at idle? The purpose of the fan clutch is to disengage it when you are moving and have enough air flow without it. It must engage when you are stopped. |
| | | | | | |  | |  | | |
May 15, 2006, 12:00 AM
|
#8
| | New Member
Join Date: Jan 2006
Posts: 7
| Heater core leaking-replace. Overheating, possibly wrong type of fan clutch installed. The type you need is a thermostatic clutch. |
| | | | | | | | Thread Tools | | | | Display Modes | Linear Mode | |