Hi guys .... I have a 94 eg civic hatch back 1.5 non vtec and well to the problem i went to change my ignition leads today car was starting perfect before .. but now when i connect up the ignition leads both old and new set the car wont start .. when all four are connected . So i removed one of the leads ( far right one when facing the engine ) and the car struggles but will start with only the three connected but when the fourth is inserted again no start does anyone have any help as to what could be the problem Thanks for any help guys

Lonso

RickJ

Be sure to check out the excellent post that our Auto Expert wrote up:
http://www.askmehelpdesk.com/cars-trucks/faq-honda-civic-wont-start-read-here-before-you-post-9924.html

It's stuck to the top of this board.

smiler863

Hi ive already looked at that post very informative . but the car does start when you have three leads in obviously very poorly but will start which rules out igniters or coil as there is power going through and there are no ecu codes present either i have new leads also and new plugs it only wont start when they are all connected Could the distributer cap cause this ..

CroCivic91

You may have your spark plug wires connected wrong. Did you take off ALL wires, then went to connect them ALL back again, or did you do one by one? It's very easy to mess up the order if you take them off all at the same time.

Search online for "honda fire order" or something like that...you should find a picture. If you don't, I can make you one in about 10 hours.

smiler863

Thanks mate yeah i took them all off at once if you could do a picture that would be great mate thanks

CroCivic91

Here it is...it's from a '90 Civic, but i think it should be the same for all Honda engines.

Attached Images

 

smiler863

Hi thanks for all the help guys it was the fireing order .. slightly different from the pics but very appriciated thanks again guys