Ask Experts Questions for FREE Help!
Ask    ||    Answer
 
Advanced  
 

Ask QuestionsprogressAnswer QuestionsprogressBuild ReputationprogressBecome an Expert
 
Free Answers in 3 Easy Steps

Register Now
3 Steps

At Ask Me Help Desk you can ask questions in any topic and have them answered for free by our experts. To ask questions or participate in answering them you must register for a free account. By registering you will be able to:
  • Get free answers from experts in any of our 300+ topics.
  • Accept money for answers that you provide.
  • Communicate privately with other members (PM).
  • See fewer ads.

Home > Home & Garden > Cars & Trucks   »   89 honda CRX no spark/ no ecu blinks

 
Thread Tools Search this Thread Display Modes
Question
 
 
#1  
Old Oct 23, 2006, 01:27 AM
dj16bit
New Member
dj16bit is offline
 
Join Date: Sep 2006
Posts: 9
dj16bit See this member's comment history on his/her Profile page.
89 honda CRX no spark/ no ecu blinks

I just purchased a 89 crx and and the car would not start, fuel issue . I unpluged the harness and there was no power going to the fuel pump so I ran power to the fuel pump and I was able to start the car. I noticed that the fuel gauge was not working so I asumed that the extra two cables in the fuel pump hardness had something to do with the fuel gauge. I touched the wrong cables while the car was running and it sparked and the car turned off. No ignition spark After disconecting the battery terminal for 30 seconds and turning the ignition on, I replaced the main relay and tryed a different ecu,same thing.
I checked all fuses and the coil has power i am assuming it's the igniter?

help please

Reply With Quote
 
     

Answers
 
 
Old Oct 23, 2006, 09:27 AM   #2  
Senior Cars & Trucks Expert
TxGreaseMonkey is offline
 
TxGreaseMonkey's Avatar
 
Join Date: Jun 2006
Location: Undisclosed, Republic of Texas
Posts: 7,725
TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.
Did you check all fuses with a multimeter? Pay particular attention to the ACG (S) fuse, probably under-dash Fuse #24. If this isn't the solution, then I would replace the igniter, like you said. Many auto part stores will test igniters/coils for free.

Comments on this post
dj16bit agrees: Helped me pin point the issue
  Reply With Quote
 
     
 
 
Old Dec 16, 2006, 12:20 PM   #3  
New Member
dj16bit is offline
 
Join Date: Sep 2006
Posts: 9
dj16bit See this member's comment history on his/her Profile page.
Finally figured it out with the help of everyones advise. I checked all the fuses but there was one that I most of over looked. After replacing the main relay, ecu and ignitor I realized that the harness for the main relay only had one wire with 12v. I found a bad fuse under the dash that powered the main relay and tested the harness, after installing the new fuse I was getting power from multiple cables with the ignition on. At that point I plugged in my original main relay and the ecu warning light would finally turn off after a few second and the car crank up with the original ECU and ignitor.
I feel like dork because I checked all fuses 3 times and could of had this car running two months ago, but you learn from mistakes some times and you guys have been very helpful.
Thanks again for posting,
dj16bit
  Reply With Quote
 
     
 
 
Old Dec 16, 2006, 12:31 PM   #4  
Senior Cars & Trucks Expert
TxGreaseMonkey is offline
 
TxGreaseMonkey's Avatar
 
Join Date: Jun 2006
Location: Undisclosed, Republic of Texas
Posts: 7,725
TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.TxGreaseMonkey See this member's comment history on his/her Profile page.
We rejoice with you, dj16bit! Good job.
  Reply With Quote
 
     
 
 
Old Jun 20, 2009, 03:03 PM   #5  
New Member
pinoyren is offline
 
Join Date: Jun 2009
Posts: 1
pinoyren See this member's comment history on his/her Profile page.
Well i dont know if you still look at this thread, but which fuses did you change. I think i am having similar problems. I double triple checked the fuses. Unless you are refering to the main relay? please let me know.
  Reply With Quote
 
     

Your Answer
Email me when someone replies to my answer
Join Login





Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

 
Similar Sponsors


Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page

Similar Threads
1989 honda crx ignition switch
(2 replies)
91 honda 1.5 dx crx blows gas out intake
(4 replies)
2 Problems 1991 Honda CRX
(1 replies)
ECU input to Igniter (ICM) on 1993 Honda Civic DPFI
(0 replies)
Honda Civic (2000) ECU CVT error
(2 replies)

Search this Thread

Advanced Search

Bookmarks

Sponsors



Copyright ©2003 - 2009, Ask Me Help Desk.
All times are GMT -8. The time now is 08:15 AM.