Ask Experts Questions for FREE Help !
Ask

    Whirlpool Gold Senseon dryer won't run.

    Asked Oct 28, 2006, 05:28 PM 1 Answer
    I have a Whirlpool Gold Senseon dryer Model: GEX9868JQ0 which just quit working. Until today never gave me any problems. When I select the cycle and press "Start" I hear the relay clicking, but won't start and the "Drying Status" red indicator light "Sensing" is flashing rapidly. I have tested the air duct fuse, still good. I have pulled out the "thermistor" and checked the impedance with my ohm meter, the value was dropping while applying heat from a hair dryer. Door switch also looks good, when I press on it the light goes off. I am clueless.
    Has anybody had the same problem?

    Update:
    Just ran complete on board diagnostics and everything looks fine, but the motor won't start. Also measured voltage at P1 connector and I got 118 volts across pin 1 (black) and pin 4 (white). I didn't get anything between pins 2 and 3 (light blue/dark blue). The diagnostics manual tells me to replace the circuit board. Is this right?
    Any comments?

    Last edited by egadomski; Oct 29, 2006 at 07:55 AM.
    Search this Thread
    Share |
    1 Answer
    dhosinski's Avatar
    dhosinski Posts: 4, Reputation: 1
    New Member
     
    #2

    Aug 18, 2008, 07:36 AM
    Did this user ever get a reply? I have the same issue. I haven't tested the P1-1/P1-4 pins and I'm not sure if I get a sensing light.
    Helpful

Not your question? Ask your question View similar questions

 

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Add your answer here.


Check out some similar questions!

Error code E1 Whirlpool Senseon Dryer [ 3 Answers ]

My dryer keeps shutting off and I get an error code where the time remaining usually is that flashes E1. The only thing the manual says is to contact a repairman. I called someone a friend recommended and he cleaned it out but really didn't know anything else to do? Any help would be appreciated

Whirlpool Senseon dryer won't start [ 13 Answers ]

I have a Whirlpool Senseon electric dryer (model GEQ9858JQ0, same as in another post - "Whilrpool dryer keeps shutting off" from 2/9/06). It's about five years old. The dryer worked fine until today. We ran several loads through it just fine today, then it wouldn't start when pressing the Start...

Whirlpool senseon dryer kicking off [ 1 Answers ]

I have a Whirlpool Senseon electric dryer and it keeps kicking off with a error code of E1 does anybody know why? The manual only says to contact a repairman.

Whirlpool Senseon Dryer Blower Problem [ 1 Answers ]

I have a 3 year old Whirlpool Senseon Dryer Model GEW9868KQ1. The problem is that the Blower that is attached to the motor shaft is just dangling on the shaft. I can lock the shaft and rotate the blower either direction and it will not loosen or tighten. It almost seem like it is attached to the...

Whirlpool Senseon - loud rattle [ 5 Answers ]

The problem did not exist on previous use four days ago. Today the dryer runs normally; electronic control panel working, drum tumbles clothing, heat works and dries clothes but there is a loud metallic rattle type noise while the dryer is in operation. The rattle is consistent with the overall...


View more questions Search