Not your question?
Ask your question
View similar questions
Check out some similar questions!
I beam size to carry a 250 ton load. Its 5 feet long and the load is in the middle
[ 3 Answers ]
The 250 ton load is being applied to the center of a 2" thick plate 60" long and 48" wide by a hydraulic cylinder. The 2" plate has a 12" hole in the middle. I want to weld two I beams lengthwise along the 2" plate (one on each side) with bracing going across between the two I beams. The cylinder...
I beam size to carry a 250 ton load. Its five feet long and the load is in the middle
[ 0 Answers ]
Thanks for your reply ebaines. The 2" plate is part of a support base for a casing jack which is used to pull pipe out of the ground. The hole is where the pipe comes up through the base.The hydraulic cylinder that is used to pull the pipe is actualy a hollow cylinder that sits over the hole...
Kenmore elite front load takes a long time to go through the 2nd load
[ 0 Answers ]
My kenmore elite front load goes through the various cycles with the 1st load fine but it takes a very long time (hours) to go through the 2nd load with the same settings as the 1st.
Kenmore front load washer won't agitate/spin if load too heavy
[ 2 Answers ]
My Kenmore front loading washer, model 417.43042200, won't agitate or spin to complete the cycle if the load is too heavy, such as 5 bath towels. If I take off the back and help turn the drum in the agitate or spin mode it will agitate/spin and complete the cycle. The pump still drains the tub. If...
Kenmore elite front load heavy load not spinning
[ 0 Answers ]
My Kenmore Elite HE3 (model 11042832200) recently started having problems with heavy loads. I had a load full of towels and it wouldn't rinse/spin or drain/spin. I cancelled the cycle and took out most of the towels and it did a rinse/spin with no problem. I ran smaller loads and they completed... View more questions Search
|