Search:

Check for power to the dishwasher, check the fuse/tco on the control board, if those two things check out then you could have a bad touch control or main control board.

It could be a blown thermal fuse (if so look for any venting restrictions), bad timer, or where the cord connects to the back of the dryer look for any burned wires.

-Ryan

Two common things on your dryer will cause a squeak. The most common thing is worn out front drum support glides. A lot of times the glide get worn through and then the dryer drum starts to ride on...

They are pretty easy to replace in most cases. Most are accessed from the rear of the stove by removing the rear panel. Good luck!

It sounds like the control board could have gone bad. A lot of times when the power turns on and off like that there is a power surge, that is likely what killed it. But it could have been on its...

It sounds like you make have something stuck in one of the drum baffles. Check to see if something like a coin got stuck in one of the baffles. It won't hurt anything to have it in there, but you...

There are three components to the defrost cycle on your refrigerator. The control board, defrost thermostat, and the defrost heater. When replacing the control board on that model you have to...

Unplug the dry right away! It sounds like you have a shorted out heating element, and after the dryer overheated it blew the thermal fuse(s) which is why it won't run anymore. You will want to...

It sounds like you have a bad motor coupling, but a bad transmission can also give the same kinds of systems. The motor coupling is located between the motor and the transmission.

This is what...

According to Whirlpool with rigid venting and no turns you can vent your dryer 64ft. With flexible venting and now turns you can vent it 36ft.

That is normal on whirlpool/kenmore dryers to do that. There is nothing to worry about.

You're welcome!

Most dryers don't use start capacitors. Most likely you either have a bad motor or something is stuck in the blower fan of the motor. The motor should spin freely with nothing connected to it, if...

Is the temperature of the refrigerator correct? Check it with a thermometer. With the temp settings set in the middle, the refrig should be around 37-38 degrees and the freezer should be around 0...

One of the suspension components could be broken on the washer. I believe your washer should have two spring on the top, and four shock absorbers on the bottom. If one of those components is...

How many times does the light blink in a row before there is a pause? 7 is the most common, it means that the computer is sensing that the water is not getting hot enough. There are quite a few...

If you installed the defrost timer correctly then it should go through the automatic defrost cycle every XX hours (each timer is different, most are between 8 and 12 hours), the defrost cycle is...

There is a fan in the freezer called the evaporator fan motor, do you hear that running when you open the freezer door? On some models you will have to hold down the door switch to get the fan to...

Do it keep filling up even when the washer is unplugged (no power going to it)? If so it's a bad water inlet valve. This is what the part looks like...