Ask Experts Questions for FREE Help !
Ask
    bamckellar's Avatar
    bamckellar Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 5, 2008, 12:59 PM
    Maytag stacked Washer/Dryer Only Works On Spin
    I have a Maytag all in one washer/dryer unit. The dryer works fine. The washer has been working fine, but not when I select the cycle it will not start filling or washing. When I move the cycle up to the spin section it works fine. It will not work in the wash and rinse cycles, spin only. There were no warnings it just did this all the sudden. I checked all the water tubes and they are fine, no clogging. I tried reseting the fuse, that did not work either. It does nothing in the wash or rinse cycle, no noise or anything, but it acts normal when I move it to the spin cycle. Does anyone have any idea what is causing this or how to fix it?
    Thanks
    Credendovidis's Avatar
    Credendovidis Posts: 1,593, Reputation: 66
    -
    		  
    #2

    Apr 5, 2008, 08:58 PM
    Quote Originally Posted by bamckellar
    Does anyone have any idea what is causing this or how to fix it? Thanks
    If you set to "spin" (you say that works fine) : does that include rinsing between spinning cycles?

    Points to ponder (and check) :

    1 : in the washing mode in many washers the drum will not turn unless the water level "pressostat" is activated.

    2 : the water inlet valve is often wired in series with the heating element, so if the heating element is burned out, no water will enter the drum, resulting in the washing mode to fail.
    (that may sound strange, but works fine. To activate the heater the water inlet valve is shorted out temporally.

    Advice :
    FIRST disconnect the power lead from the socket, and put the cable on the ground in front of you : safety first!
    Only after that is done you can safely do electrical measurements with a multimeter.
    Remember that the combination of water and electricity in a washing machine are widow makers...

    Success!
    As always : if you require more info, please let me know. If this solves your problem, please rate the answer provided! Feed back is always appreciated!
    ;)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag Neptune washer LOUD spin out [ 7 Answers ]

Our refurbished Maytag Neptune washer was so quiet spinning out when we first got it two years ago. Now It is so loud when spinning out, we cannot hear each other talk. What can I do? (This is the same reason we replaced our last washer!) If it matters we do at least 15 loads a week... probably...

Maytag Washer loud noise during spin [ 2 Answers ]

I have a Maytag PAV3200AWW washer which recently started making a loud noise during the spin cycle. The sound is constant, varies directly with the speed of the tub spinning, and reminds me of a noisy bearing, or what it might sound like if the tub was trying to spin against the brake. :confused: ...

Kenmore Model 417 stacked washer/dryer agitator removal [ 2 Answers ]

There's a sheet stuck under the agitator on this machine. I've removed the cap of the agitator by unscrewing it. There's a stud under it with a 5/8" hex bolt in a very tight space. Is there a special wrench to unscrew this? I have a 5/8" socket but I doubt if it will fit over the bolt because...

Kenmore 80754 Top Load Stacked Washer / Dryer [ 1 Answers ]

My washer drum is out out balance in all spin cycles. I used to repair the old dryers where all you need to do is replace solenoids, thermostats, htg. Coils, etc... so I am somewhat familiar w/appliance repair. What do I need to do to fix this at home?

Best stacked washer and dryer [ 1 Answers ]

I am looking for the best stacked washer/gas dryer. Any recommendations?

View more questions Search