Ask Experts Questions for FREE Help !
Ask
    CPLKirkUSMC's Avatar
    CPLKirkUSMC Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 11, 2009, 09:00 AM
    Gas Furnace Won't Light
    I am trying to light my gas furnace in my house but it won't light. I light the pilot and when I turn the dial to on the flame goes away and no gas in going through! What am I forgetting or doing wrong?
    WallyHelps's Avatar
    WallyHelps Posts: 1,018, Reputation: 136
    Ultra Member
    		  
    #2

    Nov 11, 2009, 10:06 AM

    Let the pilot run for 30-60 seconds before turning the dial to "ON". This allows the thermocouple to heat up, which will allow gas to flow to the main valve. If it still goes out, I'd replace the thermocouple.

    Best of luck,
    WallyH
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Converting lp gas water heater to natural gas [ 3 Answers ]

Is it possible to convert a lp gas water to a natural gas water heater or will I need to get a new heater?

Carrier gas furnace code 31 [ 3 Answers ]

Hi. I have a Carrier gas (propane) furnace 58MCA100-11116 series 111. It shows a code 31. The evacuation blower runs for a short time then kicks off. The burners do not ignite. To date I have: replaced the pressure switch, checked in and out lines to the pressure switch for obstruction,...

Furnace won't light [ 0 Answers ]

I have a trane xr80 and it won't heat, it is 3 years old and will only run in the on position not on auto. Blows cold air only, however the flashing light says nothing is wrong.

Oil furnace won't light [ 3 Answers ]

Ran oil of oil, restarted unit, it came on and then just shut down. I can't get it to come back on to even blead the line. It is like it has no power, I have hit the reset but nothing happens, and when it is tripped the light doesn't even come on on the control (Honeywell) with 45 second delay....

My furnace won't light and the lights on my control module won't come on [ 2 Answers ]

Ok a couple of question if you can help I have a comfortmaker furnace I believe 1999 it came on a couple of times after I bought a new transformer, board, capacitator, and ignition control module now it won't come back on What to Do! Also I wanted to know if you can tell me the difference between...

View more questions Search