The bass just went on both speakers?

Just trying to make a little sense. The speakers are separates with both a woofer and a tweeter, correct? Only the bass part of the speaker is not working, correct?

Here are my thoughts:

Usually an amp has a DC protection system which wlll kick in and stop all output until the power is turned back on again. Speaker cabinets, themselves sometimes have a fuse, behind the grill or somewhere, but they usually protect only the high frequency drivers (Tweeters). The crossover could have broken, but that's an unlikely scenereo.

Both woofers breaking at the same time would not be unusual. I've seen tweeter fuses blow at the same time.

In any event, the drivers (woofers) should both be replaced at the same time for the best sound UNLESS the identical speaker can be had as a replacement.

Assuming no tools, you can determine if something is wrong with the speaker by:

1) disconnecting the speaker from the amp and connecting a "D" battery across it's terminals. The cone will move in or out depending on polarity.

Inspect the speaker for any signs of fuses.

Then the woofer can be removed and the same test preformed. If the cone moves the woofers are OK unless there is visible damage on the surround.

Speaker polarity is important for correct sound. Pay attention to wire colors and markings /colors on the speakers.

Yes the speakers are separates with a woofer and a tweeter, but I'm not 100% sure which part isn't working. I think it's the bass because when I adjust the bass setting nothing happens, but when I alter treble etc. It does change.

I think I'm going to have to get someone to look at it because I know nothing about the anatomy of speakers and will probably electrocute myself... I have a friend who may know what he's doing so I shall show him your reply, I'm sure it will be of use.

Thank you very much for your help.

Laura

It could have been that your amp was bigger than your sub..like if you have a 100watt amp hooked up to a 800watt sub..if this is the case you probable blew your speakers or at least part of it..or something could be rong with the electromagnet because it uses a pulse of positive and negative charges to move..check to see what your watts are in your sub and amp then check the magnet itself..let me know how that works and by the way I'm only 14 hehe.