Ask Experts Questions for FREE Help!
 
Free Answers in 3 Easy Steps

Register Now		 3 Steps
 
Ask QuestionsprogressAnswer QuestionsprogressBuild ReputationprogressBecome an Expert
 
At Ask Me Help Desk you can ask questions in any topic and have them answered for free by our experts. To ask questions or participate in answering them you must register for a free account. By registering you will be able to:
  • Get free answers from experts in any of our 300+ topics.
  • Accept money for answers that you provide.
  • Communicate privately with other members (PM).
  • See fewer ads.
  Answer this Question    Ask about Heating & Air Conditioning    Ask about another Subject  
 
PDA

fraserjim
Nov 7, 2009, 08:42 AM
York Diamond
fraserjim
Nov 7, 2009, 08:50 AM
Sorry - hit wrong button. More detail.

York Diamond D 80 - 2 stage
RTH7500D Thermosat

Blowing cold air - no burner, main fan running, flash 7

Furnace works fine wen first turned on. Heats house. Problem seems to occur after running awhile or when trying to restart?

Always have seen great ignition sequence. Small fan turns on, ignitor glows strongly, gas on, strong flame, after some seconds, more gas and main fan on.

Have to turn furnace power off to reset. Always restarts fine.

Cleaned flame sensor with steel wool. No difference.

Maybe bad flame sensor? I have recording DVM. What is the output range for the flame sensor?

Any other ideas?

Thx. Fraser Jim
KC13
Nov 7, 2009, 09:41 AM
Flame sensor failure is very rare. There should be a legend somewhere on the unit to describe what the LED is displaying.
fraserjim
Nov 7, 2009, 12:11 PM
I cannot find a ledgend, but a York manual for a similar furnace says that a Flash 7 means that "flame could not be established". "Could be low gas pressure, faulty gas valve, bad igniter, burner problem".

When I look at sequence, it normally starts fine, and exhibits no symptoms from above, so that is why I'm thinking sensor.

Fraser Jim