furnace starts proper operation fires 10 seconds later goes out checked pressure switch replaced pressure switch still have problem i noticed a drip comind from the bottom of the motor and i also had a bad rainstorm is it possible the pvc exhaust is full of water

quote( i also had a bad rainstorm is it possible the pvc exhaust is full of water)
not likly,at least not from the rainstorm,,

are you getting a code on your circut board(blinking light)

Do the popular thing and clean the flame sensor. Everybody's doing it these days, it's trendy but fashionable.

furnace starts proper operation fires 10 seconds later goes out checked pressure switch replaced pressure switch still have problem i noticed a drip comind from the bottom of the motor and i also had a bad rainstorm is it possible the pvc exhaust is full of water


WE have pictures.

it flashes 3 times meaning pressure switch stuck open i changed switch and still had the same problem

Clean sensor?

You mentioned water...if the condensate trap is clogged, a flooded secondary heat exchanger could result in problems keeping the pressure switch engaged.

WE have pictures.

Admit it. You get a nickel for every time you post that pic don't ya? :p

Sure but it is a dime