We were told the original Module S8600M is now replaced with a universal one 8610 U by Honeywell!

I am unablke to get the furnace going with that new module !

The old one works Ok !! GO FIGURE !

What do i have to do to get the Universal going since the old model is not available .Al wires were put into same socket

TEMPSTAR FURNACE 90 er
AL

If th eold one works ok as you stated then why are you replacing it?

Make sure to check the ground. The ground is of most importance on these moduals. Also note only a ON SITE professional HVAC repair person should attempt to install and check out these control devices. You are playing with gas controls and unless you know exactly what you are doing you and your family can be hurt besides the damage that can be caused to your furnace.

http://customer.honeywell.com/techlit/pdf/PackedLit/69-1955.pdf

Was told by the stupid gas company guy it could be the module !
Go figure !

Does the furnace work with the old module? Or is there a problem with the furnace and the gas company figured it was the board. You say the old module works fine, so i ask the same question as markwithak, why replace. If there is a problem with the operation of the furnace, give us some details(preferably with the old board installed) and one of us may be able to help. And as far as gas companys trying to fix furnaces. They usually dont know what they are doing, they are in the business of selling gas and maintaining gas lines, not trouble shooting complicated pieces of heating equiptment.


Ps. All you gas guys out there, stick to your trade, and make my life a little easier by not working on water heaters, furnaces, or anything beyond the meter. You make enough money on your gas sales, why steal work from plumbers and hvac techs.

After spending $96.00(not returnable ) Had the heating repairman come out and found it was the Orifice clogging on the pilot light !

For lousy 79.00 he got it going .

However, the guy could not figure out how to use the# 8610U Universal ,too ! FUNNY

That tempstar 90ER unit has no curcuit board (19 years old)

Go figure !

Thanks anyway
Al

Correctioin I had delyed ignition before !!!

Al

Ah see, if you had known that (and stated that at first) this proble would have been solved within 1 or 2 replies lol.

Thanks form your input !

Just glad you got it fixed.

But I am still holding the new 8610 U cost 96.00!?

The heating guy could not figure out how to apply that unit !!!!!!!!!!!!!!!!

The 8600 is replaced with that 8610 U module Honeywell !
COULD SOMEONE TELL ME HOW THIS COULD BE ADAPTED,SO NEXT TIME I WILL TELL HIM

look here: it is the diagram!

Thanks

Same here