What is the test procedure for a ballast. I would like to know how wired up in light and a bench test. Thank you in advance for any help. :eek:

I may have about 100 fluorescent fixtures I have been taking care of years. Invariably, if new bulbs don't light, changing the ballast will fix the problem. When you open up the light, you might make sure the ballast is getting power, and no obvious open connections. Also, some older fixtures require a working starter.

If somebody can post a simple test, I would be very happy to see it.

Please provide the type of ballast. The manufacturer and model number is best. If unknown, please provide the quantity and type of lamps the balast is designed for. For example, is it for 2- 4 foot F40 T12 lamps, which is a rapid start ballast, or is it for 2- 8 foot F96T12 lamps, which is a slimline ballast.

These are the two basic , most popular type ballasts. There are several other types, the type would be helpful, as each type has it's own specifc testing procedure for testing the actual ballast itself.

Please explain further what you are actually looking to do, create a test benchset to test several ballasts? Or??

2 bulb 8 Ft The bench test is because I have several used ballast that I don't know if the are good or not. Thought it would be eaiser to test them before installation.

Sorry for the delay. Here is a link to a troubleshooting guide for ballasts. See the section regarding slimline ballasts.

http://www.advancetransformer.com/uploads/resources/flb-troubleshooting-guide-2.pdf

You may want to set up a fixture on the bench to connect each ballast one by one to test each operation, if the guide is a bit too much what you may be looking for.

What is the test procedure for a ballast. I would like to know how wired up in light and a bench test. Thank you in advance for any help. :eek:
How do I test a ballast?

How do I test a ballast?

emc2, wiring diagram is usually on most ballast.
I usually don't test the ballast. If known good bulbs don't work, I usually check supply voltage into ballast and the Ground(Important), The only thing left is the sockets or the wires into them.
The link provided by TK is very helpful.
Bulbs are quick and cheap. If the ends of the bulbs are dark or black, Replace.
Anyone testing a lot of the same Ballast. I would start with a working fixture and have quick way of making and breaking the connections, as well as power off switch, for use during swapping ballast.