Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Grounding rods sticking out - correct installation?
[ 18 Answers ]
Hi - I just had my old 100 amp panel replaced with a 200 amp panel, and as part of the process two grounding rods were driven, and a new mast was installed. I'm hoping it was done correctly, but some of the choices made by the electrician just don't look right to me. I have not had the work...
Proper Grounding
[ 5 Answers ]
I am installing a new electric Service to my home. I am upgrading to a 200 amp service and relocating the meter box. I plan on using #3/0 wiring from the meter box to the Load Center, then using #2/0 from the ground rod to the meter box and the Load Center. I have 2 questions. First, Do I need...
Proper grounding for 400A service and adjoining panel
[ 1 Answers ]
I am installing a 400A service panel on the outside wall of a garage. For the time being it will only be supplying power to a 125A panel located on the inside wall of that garage. The 125A panel will be mounted inside the wall directly behind the 400A service, and the two will be connected by...
New main breaker load center - grounding
[ 1 Answers ]
I currently have a fuse box that I want to upgrade to a main breaker load center. My house is in the country so I have a pole with the meter and a service disconnect. From the service disconnect it braches to my barn, well pump, and the house. (Following the main into the house) Inside on...
Question on proper use of GFIC breaker
[ 1 Answers ]
I had some outdoor receptacles recently installed and would like to know if it is proper to put a GFIC breaker in the panel for this circuit and will it protect the receptacles from shorting instead of putting a GFIC receptacle in the circuit? View more questions Search
|